Engine oil - checking and filling

The oil level is detected with the electronic oil level sensor.
P4-1420 Filler cap engine VEP4
Filler pipe1.

In some cases, oil may need to be topped up between service intervals.

No action needs to be taken on engine oil level until a message is shown in the combined instrument panel's display, see the following illustration.

P3-1346 Oil message and graph in display VEA
Message and graphic in the display. The left-hand display is shown in the digital combined instrument panel and the right-hand in the analogue.
  1. Ikon röd cirkel 1Message
  2. Ikon röd cirkel 2Engine oil level

The oil level is checked using the electronic oil level gauge with the thumbwheel when the engine is switched off, see Menu navigation - combined instrument panel.

 Warning

If the message Oil service required is shown, visit a workshop - an authorised Volvo workshop is recommended. The oil level may be too high.

 Important

If notified of low oil level, only fill with the volume specified, for example, 0.5 litres.

 Note

The system cannot directly detect changes when the oil is filled or drained. The car must have been driven approx. 30 km and have been stationary for 5 minutes with the engine switched off and on level ground before the oil level indication is correct.

 Warning

Do not spill oil onto the hot exhaust manifold due to the risk of fire.

Measuring the oil level

 Note

If the right conditions for measuring the oil level are not met (time after engine shutdown, the car's inclination, outside temperature, etc.) then the message Not available will be shown. This does not mean that there is something wrong in the car's systems.
  1. 1 Engines with electronic oil level sensor do not have a dipstick.