CTA*

The BLIS function CTA (Cross Traffic Alert) is a driver aid intended to warn about crossing traffic when the car is reversing. CTA is a supplement to BLIS.

Activate/deactivate CTA

CTA is activated when the engine is started. This is confirmed by the indicator lamps in the door panels flashing once.

P4-1220-Parkeringshjälp På-/Av-knapp
On/Off for parking assistance and CTA sensors.

In cars equipped with Parking assistance, the CTA function can be deactivated/activated separately with the parking assistance On/Off button.

In cars without a button for parking assistance, the CTA function can be operated in the menu system MY CAR, MY CAR, as follows:

  • Search for Cross Traffic Alert under BLIS and uncheck - the CTA function is then deactivated.

However, the BLIS function remains activated after the CTA has been deactivated.

 Warning

CTA is a supplementary aid and does not work in all situations.

CTA is no substitute for a safe driving style and the use of rearview and door mirrors.

CTA can never replace the driver's responsibility and attention - it is always the driver's responsibility to reverse in a safe manner.

When CTA operates

P4-1220-CrossTrafficAlert Princip
Principle for CTA.

CTA supplements the BLIS function by being able to see crossing traffic from the side during reversing, such as when reversing out of a parking space.

CTA is primarily designed to detect vehicles. In favourable conditions, it may also be able to detect smaller objects, such as cyclists and pedestrians.

CTA is only active during reversing and is activated automatically when reverse is selected at the gearbox.

  • If CTA detects something approaching from the side, an acoustic warning signal sounds. The signal comes from either the left or the right speaker depending on which direction the approaching object is coming from.
  • CTA also warns by illuminating the BLIS lamps.
  • An additional warning is provided in the form of an illuminated icon in the display screen's PAS graphics.

Limitations

CTA does not perform optimally in all situations, but has a certain limitation - for example, the CTA sensors cannot "see" through other parked vehicles or obstructing objects.

Here are some examples of when CTA's "field of vision" may be limited from the beginning and approaching vehicles cannot therefore be detected until they are very close:

P4-1320-CrossTrafficAlert Princip-Exception1
The car is parked deep inside a parking slot.
  1. Ikon röd cirkel 1Blind CTA sector.
  2. Ikon röd cirkel 2Sector where CTA can detect/"see".
P4-1320-CrossTrafficAlert Princip-Exception2
In an angled parking slot CTA can be completely "blind" on one side.

However, when the driver is slowly reversing the car, the angle is changed in relation to the vehicle/object that is blocking, at which the blind sector rapidly decreases.

Examples of further limitations:

  • Dirt, ice and snow covering sensors can reduce functionality and make it impossible to provide warnings. CTA cannot detect hazards if it is covered.
  • CTA is deactivated when a trailer is connected to the car’s electrical system.

 Important

Repair of the BLIS and CTA functions' components or repainting the bumpers must only be performed by a workshop - an authorised Volvo workshop is recommended.

Maintenance

The sensors for the BLIS and CTA functions are located inside the rear wing/bumper on each corner of the car.

P4-1420- CrossTrafficAlert sensor
Keep this surface clean - also on the left-hand side.
  • To ensure optimal functionality, the areas in front of the sensors must be kept clean.
  • Do not affix any objects, tape or labels in the area of the sensors.
  1. * Option/accessory.