Lane Keeping Aid - symbols and messages

Lane Keeping Aid is one of the functions in the Driver Alert System - sometimes also referred to as LKA (Lane Keeping Aid).

The function is intended for use on motorways and similar major roads in order to reduce the risk of the vehicle accidentally leaving its own lane in certain situations.

In situations where there is no LKA function or it is interrupted, a symbol may be shown in the combined instrument panel in combination with an explanatory message - follow the recommendation given if appropriate.

Message examples:

Symbol1MessageSpecification
Lane Keeping Aid Unavailable at this speedLane Keeping Aid is set in standby mode due to speed being lower than 65 km/h.
Lane Keeping Aid Unavailable for current markingsThe lane does not have clear side lines or the camera sensor is temporarily disengaged. Read about the limitations of the camera sensor, see Collision warning system* - camera sensor limitations and Collision warning system* - operation.
Lane Keeping Aid AvailableThe function scans the lane's side lines.
P4-1246-Symbol Kamera BlockeradWindscreen sensors blocked See manual

The camera sensor is temporarily disengaged.

Shown in the event of snow, ice or dirt on the windscreen for example.

  • Clean the windscreen surface in front of the camera sensor.

Read about the limitations of the camera sensor, see Collision warning system* - camera sensor limitations and Collision warning system* - operation.

P4-1246-Symbol Lane-Keeping-Aid-!Lane Keeping Aid Service required

The system is disengaged.

  • Visit a workshop if the message remains - an authorised Volvo workshop is recommended.
Lane Keeping Aid Interrupted LKA has been set to standby mode. The lines of the LKA symbol indicate when the function is active again.
  1. 1 The table's symbols are schematic. The symbols shown in the combined instrument panel may have a slightly different appearance.
  2. * Option/accessory.

Related documents