Driver's door control panel.
Check that children or other passengers are not trapped when the windows are closed from the driver's door.
Check that children or other passengers are not trapped if/when the windows are closed using the remote control key.
If there are children in the car - remember to always switch off the power supply to the power windows by selecting key position 0 and then take the remote control key with you when leaving the car. For information on key positions - see Key positions - functions at different levels.
Operating the power windows.
All power windows can be operated using the control panel for the driver's door - the control panels for the other doors can only operate their respective power window. Only one control panel can be operated at a time.
In order for the power windows to be used, the key position must be at least I - see Key positions - functions at different levels. The power windows can be operated for a few minutes after the engine has been switched off and after the remote control key has been removed - although not after a door has been opened.
Closing of the windows is stopped and the window is opened if anything prevents its movement. It is possible to override the pinch protection when closing has been interrupted, e.g. if there is ice forming. After two successive closing interruptions the pinch protection will be forced and the automatic function deactivated for a short while, now it is possible to close by continually holding the button pulled up.
One way to reduce the pulsating wind noise when the rear windows are open is to also open the front windows slightly.
Operating without auto
Move one of the controls up/down gently. The power windows move up/down as long as the control is held in position.
Operating with auto
Move one of the controls up/down to the end position and release it. The window runs automatically to its end position.
If the battery is disconnected then the function for automatic opening must be reset so that it can work correctly.
Gently raise the front section of the button to raise the window to its end position and hold it there for one second.
Release the button briefly.
Raise the front section of the button again for one second.
A reset must take place for pinch protection to work.