Active park assist

Limitations of Park Assist Pilot*

Обновления 1/31/2020

Limitations of Park Assist Pilot*

The Park Assist Pilot (PAPPark Assist Pilot) function cannot detect everything in all situations and may therefore have limited functionality.

Предупреждение

  • The parking sensors have blind spots where obstacles cannot be detected.
  • Pay particular attention if there are people and animals near the car.
  • Bear in mind that the front of the car may swing out towards oncoming traffic during the parking manoeuvre.

Предупреждение

  • The function is supplementary driver support intended to facilitate driving and make it safer – it cannot handle all situations in all traffic, weather and road conditions.
  • The driver is advised to read all sections in the Owner's Manual that relate to this function to learn about factors such as its limitations and what the driver should be aware of before using the system.
  • Driver support functions are not a substitute for the driver's attention and judgement. The driver is always responsible for ensuring the car is driven in a safe manner, at the appropriate speed, with an appropriate distance to other vehicles, and in accordance with current traffic rules and regulations.

Важно!

Objects situated higher than the sensor detection area are not included when calculating the parking manoeuvre, which could cause the function to swing into the parking space too early – such parking spaces should be avoided for this reason.

A driver should be aware about the following examples of Park Assist Pilot limitations:

Parking is discontinued

A parking sequence will be discontinued:

  • if the driver moves the steering wheel
  • if the car is driven too quickly - above 7 km/h (4 mph)
  • if the driver presses Cancel in the centre display
  • when the anti-lock brakes or the Electronic stability control are engaged - e.g. when a wheel loses grip on a slippery road
  • as the steering servo for speed-dependent steering wheel resistance is working at reduced power – e.g. when cooling due to overheating.

Where applicable, a message in the centre display states the reason for a parking sequence being discontinued.

Важно!

Under certain circumstances, the function is unable to find parking spaces - one reason for this may be the fact that there is interference with the sensors from external sound sources which emit the same ultrasound frequencies as those with which the system works.

Examples of such sources include horns, wet tyres on asphalt, pneumatic brakes and exhaust noises from motorcycles etc.

Примечание

Dirt, ice and snow covering the sensors will reduce their function and may prevent measurement.

Driver responsibility

The driver should bear in mind that the function is an aid – not an infallible, fully-automatic function. The driver must therefore be prepared to interrupt a parking step.

There are also a few details to bear in mind while parking, e.g.:

  • The driver is always responsible for determining whether the space selected by the function is suitable for parking.
  • Do not use the function if snow chains or a spare wheel are fitted.
  • Do not use the function if cargo items are protruding from the car.
  • Heavy rain or snow may cause the system to measure the parking space incorrectly.
  • During the search and check-measurement of the parking space, the function may miss objects positioned deep in the parking space.
  • Parking spaces on narrow streets are not always feasible, since the space required for manoeuvring may not be sufficient.
  • Use approved tyres

    ”Approved tyres” refers to tyres of the same type and make as those fitted new on delivery from the factory.

    with the correct tyre pressure - this affects the ability of the function to park the car.
  • The function bases itself on the locations of vehicles already parked nearby – if they are inappropriately parked, your own car's tyres and wheel rims may be damaged by contact with the kerb.
  • Perpendicular parking spaces may be missed or offered unnecessarily if one parked car is protruding more than other parked cars.
  • The function is designed for parking on straight streets – not sharp curves or bends. For this reason, make sure the car is parallel to the potential parking spaces when the function measures the space.

Важно!

Changing to another approved wheel rim and/or tyre dimension may involve a changed tyre circumference, which means that the system's parameters may then need to be updated. Consult a workshop - an authorised Volvo workshop is recommended.


Это помогло?