Controls - beam/lighting

Position lamps

Updated 1/14/2020

Position lamps are switched on using the headlamp control's knob.

P3-1320 Parking lights, 4-position handle

Knob for headlamp control in the position for position lamps.

Turn the knob to the position for (number plate lighting is switched on at the same time).

If the car's electrical system is in key position II or the engine is running then the daytime running lights are switched on instead of the front position lamps.

When it is dark outside and the boot lid is opened the rear position lamps illuminate to alert traffic behind. This takes place irrespective of what position the knob is in or what key position the car's electrical system is in.

When driving for more than 30 seconds at max. 10 km/h (approx. 6 mph), or if the speed exceeds 10 km/h (approx. 6 mph), the daytime running lights are switched on and Reset light switch position is shown in the combined instrument panel, which prompts you to turn to a mode other than .


Did this help?