The camera image is shown on the centre console's screen.
When a towbar is configured with the car's electrical system, the protrusion of the towbar is included when the function measures the parking space.
- The parking camera serves as an aid. It does not relieve the driver of responsibility when reversing.
- The camera has blind spots, where obstacles cannot be detected.
- Be aware of people and animals in the vicinity of the car.
Function and operation
Camera location next to the opening handle.
The camera shows what is behind the car and if something appears from the sides.
The camera shows a wide area behind the car and part of the bumper and any towbar.
Objects on the screen may appear to tilt slightly - this is normal.
Objects on the display screen may be closer to the car than they appear to be on the screen.
If another view is active then the parking camera system takes over automatically and its camera image is displayed on the screen.
When reverse gear is selected, two unbroken lines are shown graphically which illustrate where the car's rear wheels will roll with the current steering wheel angle - this facilitates parallel parking, reversing into tight spaces and for hitching a trailer. The car's approximate external dimensions are illustrated by means of dashed lines. The park assist lines can be deactivated - see section Settings .
If the car is also equipped with Parking assistance sensors * then their information is shown graphically as coloured areas in order to illustrate distances to detected obstacles, see heading "Cars with reversing sensors" later in the text.
The camera is active approx. 5 seconds after reverse gear has been disengaged or until the car's speed exceeds 10 km/h (6 mph) forward or 35 km/h (22 mph) backward.
The camera image is adjusted automatically according to prevailing light conditions. Because of this, the image may vary slightly in brightness and quality. Poor light conditions can result in a slightly reduced image quality.
Keep the camera lens clear of dirt, snow and ice to ensure optimum function. This is particularly important in poor light.
Park assist lines
Examples of how the park assist lines can be displayed for the driver.
The lines on the screen are projected as if they were at ground level behind the car and are directly related to steering wheel movement, which shows the driver the path the car will then take - also when the car is turning.
- When reversing with a trailer which is not connected electrically to the car, the lines on the display show the route the car will take - not the trailer.
- The screen shows no lines when a trailer is connected electrically to the car's electrical system.
- The parking camera is deactivated automatically when towing a trailer if a Volvo genuine trailer cable is used.
Remember, that with the rear camera view selected, the monitor only displays the area behind the car. Be aware of the sides and front of the car when manoeuvring in reverse.
The system's different lines.
|Boundary line, free reversing zone|
The dashed line (1) frames in a zone up to about 1.5 m back from the bumper. It is also the limit of the car's most protruding parts, such as door mirrors and corners - also when the car is turning.
The wide "wheel tracks" (2) between the side lines indicate where the wheels will roll and can extend about 3.2 m back from the bumper if no obstacle is in the way.
Cars with reversing sensors*
Coloured fields (one per sensor) show distance.
If the car is also equipped with Parking assistance the distance is shown with coloured fields for each sensor that registers an obstacle.
The colour of the areas changes with decreasing distance to the obstacle - from light yellow to yellow, via orange to red.
Colour / paint