Aim the remote control towards the HomeLink® button to be programmed and hold it approx. 2-8 cm (approx. 1-3 inches) from the button. Do not obstruct the indicator lamp on HomeLink®.
Press and hold depressed both the button on the remote control and the button to be reprogrammed on HomeLink®.
Do not release the buttons until the indicator lamp has switched from flashing slowly (approx. once per second) to either flashing quickly (approx. 10 times per second) or illuminating with a constant glow.
If the indicator lamp illuminates with a constant glow: Indication that the programming has finished.
Press the programmed button twice to activate.
If the indicator lamp flashes quickly: The device to be programmed to HomeLink® may have a security function that requires extra steps.
Test by pressing the programmed button twice to see whether the programming is working. Otherwise, continue with the following steps.
Locate programming buttonButton designation and colour varies between manufacturers. on the receiver for the garage door or similar. It is normally located close to the antenna's bracket on the receiver.
Depress and release the receiver's programming button once.
The programming must be completed within 30 seconds of the button being depressed.
Press and release the button on HomeLink® that you want to program. Repeat the sequence of pressing/holding/releasing a second time and, depending on the receiver model, even a third time.
Programming is finished.
The ability of some remote controls to program HomeLink® is improved at a distance of approx. 15–20 cm (approx. 6–12 inches).
Reprogramming individual buttons
Press the desired button and hold it depressed for approx. 20 seconds.
Once the indicator lamp on HomeLink® starts to flash slowly, programming can continue as normal.
If the button to be reprogrammed is not programmed with a new unit, it will resume the previously saved programming.
Resetting the HomeLink® buttons
It is only possible to reset all HomeLink® buttons at the same time. Individual buttons can only be reprogrammed.
Press and hold depressed the outer buttons on HomeLink® for approx. 10 seconds.
When the indicator lamp changes over from a constant glow to starting to flash, the buttons are reset and ready to be reprogrammed.
Problems with programming
Visit homelink.com or call 00 8000 466 354 65 (or premium charge number +49 6838 907 277)Note that the toll-free number may not be available depending on operator..