An automatic car wash may be a quick and easy way to clean the car, but will not reach all the parts of the car that need to be cleaned on a regular basis. Volvo recommends supplementing automatic car washing with hand washing.
Avoid washing a brand new car in an automatic car wash during the first few months. This would allow the paintwork to fully harden.
Preparations before washing
In an automatic car wash where the car is pulled through the car wash, it is important to switch off functions that prevent the car from rolling freely.
- Secure or remove protruding exterior parts such as retrofitted auxiliary lamps and antennas.
- Make sure that the automatic rain sensor function is deactivated. The windscreen wipers must be switched off the whole time the car is being washed to avoid the risk of damage.
- Deactivate the automatic braking at standstill function using the button on the tunnel console.
- Deactivate the warning and auto-brake when reversing functions in the centre display's parking camera view. They may be reactivated if the car is restarted, and must be deactivated again.
Keep the windows, doors and tailgate closed the whole time the car is being washed.
If the car is equipped with keyless locking and unlocking*:
Take out the key and store it openly in the front part of the car while the car is being washed. This minimises the risk of opening the tailgate unintentionally by pressing a button, or that the key is incorrectly detected outside the car.
Drive into the car wash and stop at the designated location.
Select gear position N.
Set the car in ignition position 0 by turning the start knob in the tunnel console clockwise for several seconds.
The engine is switched off, and at the same time the car can roll freely.
The car travels through the automatic car wash.
Keep the seatbelt fastened the whole time the car is being washed.
Do not forget to restore the adjustments that were made before the car wash.
Press the brake pedal gently for a short time while driving after the brake linings have been exposed to the wetness. This heats the brakes with friction so that they dry more quickly and reduces the risk of corrosion.
Always test the foot brake and parking brake after washing the car in order to restore their function.