Temporary deactivation/standby mode
To temporarily disengage the adaptive cruise control and set it in standby mode:
- Press the steering wheel button
|This symbol and the stored speed's marking then change colour from GREEN to WHITE.|
Standby mode due to driver intervention
The adaptive cruise control is temporarily disengaged and set automatically in standby mode if:
- the foot brake is used
- the clutch pedal is depressed for longer than 1 minute
Disengaging and selecting a higher or lower gear does not involve standby mode.
- the gear selector is moved to N position (automatic gearbox)
- the driver maintains speed higher than the stored speed for longer than 1 minute.
The driver must then regulate the speed.
A temporary increase in speed with the accelerator pedal, e.g. during overtaking, does not affect the setting - the car returns to the last stored speed when the accelerator pedal is released.
Automatic standby mode
The adaptive cruise control is dependent on other systems, e.g. Stability system ESC. If any of these systems stops working, the adaptive cruise control is deactivated automatically.
In the event of automatic deactivation a signal will sound and the message Adaptive cruise control cancelled is shown in the combined instrument panel. The driver must then intervene and adapt the speed and distance to the vehicle ahead.
An automatic deactivation can be due to:
- the driver opens the door
- the driver takes off his seatbelt
- engine speed is too low/high
- speed has fallen below 30 km/h
Does not apply to a car with Queue Assist - it can go all the way down to 0 km/h.
- wheels lose traction
- brake temperature is high
- the radar sensor is covered e.g. by wet snow or heavy rain (radar waves blocked).
Resume set speed
Adaptive cruise control in standby mode is reactivated with one press on the steering wheel button - the speed is then set to the last stored speed.
A pronounced increase in speed may occur after the cruise control has been reactivated with the button.