Activating and setting the speed
To enable cruise control:
- Press the steering wheel button for CRUISE (without speed limiter) or (with speed limiter).
|>||The cruise control symbol (6) in the combined instrument panel illuminates - cruise control is in standby mode.|
To activate cruise control:
- At the required speed - press the steering wheel button or .
|>||The current speed is stored in memory and the combined instrument panel's marking (5) illuminates at the selected speed and the symbol (6) changes from GREY to WHITE - the car then follows the stored speed.|
Cruise Control cannot be enabled at speeds below 30 km/h.
When speed exceeds 120 km/h the driver is alerted of this with 3 "plings".
Changing the stored speed
Stored speed is changed with short or long presses on the or button.
To adjust +/- 5 km/h:
- Use short presses - each press gives +/- 5 km/h.
To adjust +/- 1 km/h:
- Hold the button depressed and release when the combined instrument panel's mark is by the desired speed.
Last press made is stored in the memory.
If speed is increased using the accelerator pedal prior to pressing the / button, then it is the car's current speed when the button is pressed that is stored.
A temporary increase in speed with the accelerator pedal, e.g. during overtaking, does not affect the setting - the car returns to the last stored speed when the accelerator pedal is released.
If any of the Cruise Control buttons are held depressed for several minutes then it is blocked and deactivated. To be able to reactivate Cruise Control, the car must be stopped and the engine restarted.