Loading

Operating cargo cover*

Updated 11/9/2020

Operating cargo cover*

There are two extended positions for the cargo cover - a full-cover position and a loading position, where it is partially extended to make it easier to reach further into the cargo area.

Full-cover position

For 7-seat car

P5-1646-XC90-7 seat-seat belt hooked

Hang up the locking tabs of the seatbelts for the third seat row on the designated hooks in the side panels.

P5-1646-XC90-7 seat-load cover

Grip the handle and pull out the cargo cover so that it slides over the side panels in the cargo area. Pull to the end position.

When the cargo cover is extended so that it covers the cargo area - guide the cover's attachment pins into the grooves in the side panels and release, while at the same time angling the handle with a light downward pressure.

The cargo cover is locked in the full-cover position.

For 5-seat car

P5-1646-XC90-Load cover

Grip the handle and pull out the cargo cover so that it slides over the side panels in the cargo area. Pull to the end position.

When the cargo cover is extended so that it covers the cargo area - guide the cover's attachment pins into the grooves in the side panels and release, while at the same time angling the handle with a light downward pressure.

The cargo cover is locked in the full-cover position.

Important

Do not load objects on top of the cargo cover.

Warning

In a 7-seat car, never have the cargo cover fitted when there are passengers in the rear seats. This may lead to serious injury in the event of a collision.

Loading mode

P5-1507 Load cover half expansion (new)

From retracted position - grip the handle and pull out the cover so it slides over the side panels in the cargo area - pull to the end position and guide the cargo cover's attachment pins into the grooves in the side panels. (If the cover is already in the full-cover position - see the next point)

From full-cover position - grip the handle and guide the cargo cover's attachment pins into the grooves in the side panels and release.

Retract the cover until it stops in the loading position.

In the event that your hands are occupied:

P5-1507 Load cover half expansion

In the extended full-cover position - lightly push the handle part of the cargo cover upward, e.g. with an elbow.

The cover retracts until it stops in the loading position.

To return to full-cover position from loading position:

Grip the handle and pull the cargo cover out to the end position.

Release slightly and angle the handle by means of a light downward pressure.

The cover is locked in the full-cover position.

Retracting

From the full-cover position:

Lift up the handle and pull it backward to disengage the cargo cover's attachment pins and then release.

From loading position:

Grip the handle and pull out the cargo cover in the grooves - pull to the full-cover position. Lift up the handle and pull it backward to disengage the attachment pins and then release.

Retract the cover with its attachment pins outside of the side panels until it stops in the retracted position.


Did this help?