When the car has stopped, the brakes are activated automatically. The function can use either foot brake or parking brake to hold the car stationary and it works on all gradients. When the accelerator pedal is depressed again, the brakes are released.
When braking to a stop on a downhill or uphill gradient - depress the brake pedal a bit harder before releasing to ensure that the car does not roll at all.
If the driver switches off the engine when the car is stationary, the parking brake is applied.
The function is deactivated automatically:
- when the driver's door is open and the driver's seatbelt is unfastened.
- in gear position N.
Applies to automatic gearbox.
Switch for automatic brake
An indicator in the button illuminates when the function is activated.
Activate or deactivate Auto Hold with the switch in the tunnel console. The function remains deactivated until it is reactivated.
If the function is active and holds the car with the foot brake (A-symbol illuminated) then the brake pedal must be depressed at the same time as the button is depressed in order to deactivate.
When the function is deactivated, hill start assist (HSA) remains active to prevent the car from rolling backwards when starting on an uphill gradient.
Symbols in the driver display
| || |
The symbol is illuminated when the function uses the foot brake to keep the car stationary.
| || |
The symbol is illuminated when the function uses the parking brake to keep the car stationary.