Child safety

Integrated child seat* - raising the seat cushion

Updated 7/23/2018

When the integrated child seat is in use, the seat cushion must be folded up.

The seat cushion can be folded up in two positions. The position that should be used depends on the weight of the child.

Stage 1

Stage 2

Weight

22-36 kg

15-25 kg

Stage 1

Lower stage.

P3-1246-XC60 V60 V60H Integrated child seat, opening, step 1 ill. 1

Pull the handle forwards and upwards to release the seat cushion.

P3-1246-XC60 V60 V60H Integrated child seat, opening, step 1 ill 2

Press the seat cushion backwards to lock.

Stage 2

Upper stage.

P3-1246-XC60 V60 V60H Integrated child seat, opening, step 2 ill 1

Start from the lower stage. Press the button.

P3-1246-XC60 V60 V60H Integrated child seat, opening, step 2 ill 2

Lift the seat cushion up at the front edge and press it back against the backrest to lock.

Note

It is not possible to adjust the seat cushion from stage 2 to stage 1. It must first be reset by being fully folded down into the rear seat.

Warning

If the instructions for the integrated child seat are not followed then the child could sustain serious injury in the event of an accident.

Warning

Volvo recommends that repair or replacement of the integrated child seat is only performed by an authorised Volvo workshop. Do not make any modifications or additions to the child seat. If an integrated child seat has been subjected to a heavy load, e.g. in connection with a collision, then the seat cushion, seatbelt and backrest, or possibly the whole seat, must be replaced. Even if the child seat appears to be undamaged, it may not afford the same level of protection. This also applies if the seat cushion was in lowered position during a collision or similar. The seat cushion must also be replaced if it is heavily worn.


Did this help?