Topping up coolant

The coolant cools the internal combustion engine to the correct operating temperature. The heat that is transferred from the engine to the coolant can be used to heat the passenger compartment.

When topping up the coolant, follow the instructions on the packaging. Never top up with water only. The risk of freezing increases with both too little and too much coolant concentrate.

 Warning

Coolant can be very hot. If the coolant requires topping up when the engine is at operating temperature, unscrew the expansion tank cap slowly to gently release the overpressure.
P5-1519 Engine coolant refill 1
P5-1519 Engine coolant refill 2
P5-1519 Engine coolant refill 3
P5-Icon gray box 1

Lift off the rubber strip by pressing it inward in the engine compartment.

P5-Icon gray box 2

Detach the flap in the plastic cover by folding out the release catch and turning the flap upward.

P5-Icon gray box 3

Screw off the cap and top up with coolant. The level must lie between the MIN and MAX marks on the expansion tank.

Reinstall the parts in reverse order.

 Important

  • A high content of chlorine, chlorides and other salts may cause corrosion in the cooling system.
  • Always use coolant with anti-corrosion agent as recommended by Volvo.
  • Ensure that the coolant mixture is 50% water and 50% coolant.
  • Mix the coolant with approved quality tap water. In the event of any doubt about water quality, used ready-mixed coolant in accordance with Volvo recommendations.
  • When changing coolant/replacing cooling system components, flush the cooling system clean with approved quality tap water or flush with ready-mixed coolant.
  • The engine must only be run with a well-filled cooling system. Otherwise, temperatures that are too high may occur resulting in the risk of damage (cracks) in the cylinder head.