Using an SD memory card
It is possible to use an SD memory card with Sensus Connected Touch. The card slot can be found in the device that is located in the glove compartment.
Memory and saving information
It is possible to use an SD memory card with memory up to 32 GB. Note that if you have the iGo application then this app is stored on the SD memory card.
It is possible to both read and save information on an SD memory card. If you use a USB memory for Sensus Connected Touch, it is not possible to save information on it. USB memory can only be used to read information.
Removing the SD memory card
To remove an SD memory card, follow the instructions below:
Go to Settings in the app launcher.
Select Advanced settings and then Storage.
Select Unmount the SD card and press OK.
Removing the write protection from the SD memory card
To remove the write protection from an SD memory card, follow the instructions below:
Remove the memory card by following the instructions under the heading 'Removing the SD memory card'.
There is a small switch on the SD card. Adjust the switch to the write position, and then reinsert the card in Sensus Connected Touch.
Car model/model year
V40 from and including model year 2013 to and including 2014.
S60 and V60 from and including model year 2011 to and including 2014.
XC60 from and including model year 2011 to and including 2014Model year 2011 applies only to cars manufactured after week 46..
V70, XC70 and S80 from and including model year 2012 to and including 2014.
It is possible to install Sensus Connected Touch for model year 2014 and later, but not to cars equipped with Sensus Connect.
The range of models, systems and services may vary depending on market.
For car models from and including model year 2020, see on-line manual for the model concerned.