Trip computer - analogue combined instrument panel

The car's trip computer records and calculates vales such as e.g. distance, fuel consumption and average speed whilst driving.

The information from the trip computer can be shown in the combined instrument panel and operated with the controls on the left-hand stalk switch and with the combined instrument panel's menu.

Checking and settings can be made immediately after the combined instrument panel is automatically illuminated in connection with unlocking. If none of the trip computer's controls are actuated within approx. 30 seconds after the driver's door has been opened then the instrument extinguishes, after which either key position II or engine starting is required in order to operate the trip computer.

 Note

If a warning message appears when the trip computer is used then the message must first be acknowledged before the trip computer can be reactivated.

  • Acknowledge the message by briefly pressing the indicator stalk OK button.

Controls

P4-1246-Färddator Low
Information display and controls.
  1. Ikon röd cirkel 1OK - opens the combined instrument panel's menu, confirms messages or menu selections.
  2. Ikon röd cirkel 2Thumbwheel - browses between menu options or trip computer options.
  3. Ikon röd cirkel 3RESET - resets the current trip meter or goes back out of the menu structure.

Trip computer alternative

Choose which trip computer should be shown:
To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.
Turn the thumbwheel to browse between the options and stop at the required heading.

The trip computer display in the combined instrument panel can be shifted to another option at any time during the journey. One of the options means that no trip computer is shown.

Trip computer heading in combined instrument panelInformation
Trip meter T1 and total dist.
  • Long press on RESET resets trip meter T1.
Trip meter T2 and total dist.
  • Long press on RESET resets trip meter T2.
Distance to emptyFor more information - see the section"Range - distance to empty tank".
Fuel consumptionCurrent consumption.
Average speed
  • Long press on RESET resets Average speed.
No trip computer information.This option shows a blank display and it also indicates the beginning/end of the loop.

Resetting the trip computer

Turn the thumbwheel and stop at the trip computer heading to be reset: T1 and total dist., T2 and total dist. or Average speed.

One long press on RESET resets the value for the selected heading.

Each heading must be zeroed individually.

Functions in the combined instrument panel's menu

The combined instrument panel's menu includes setting options for trip computer. Open the menu to check/adjust the functions in the table below.

To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.
Press OK.
Browse through the functions with the thumbwheel and select/confirm with OK.
Finish by pressing twice on RESET after completed checking/adjustment.
FunctionsInformation
Digital speed
  • km/h
  • mph
  • No display
Shows the car's speed digitally in the centre of the combined instrument panel.
Parking heater*
  • DIRECT START
  • Timer 1
  • Timer 2
For a description of programming the timer, see Engine block heater and passenger compartment heater* - timer.
Additional heater*
  • Auto On
  • Off
For more information, see Additional heater*.
TC options
  • Distance to empty tank
  • Fuel consumption
  • Average speed
  • Trip meter T1 and total dist.
  • Trip meter T2 and total dist.
Here you can activate the options that you want to be available as selectable headings in the trip computer. The symbols for the options already selected are white with a "tick" - others are grey and have no "tick".
Service status
Shows the number of months and the distance until the next service.
Oil level1
For more information, see Engine oil - checking and filling.
Messages (##)
For more information, see Messages.
  1. * Option/accessory.
  2. 1 Certain engines.