Preconditioning - messages

Symbols and messages regarding preconditioning.
Px-1420-Symbol Fuel heater

When the fuel-driven heater has been activated the heat symbol illuminates in the information display.

When one of the timers has been activated, the symbol for activated timer illuminates in the display at the same time as the set time is shown next to the symbol.

P4-1246 Symbol Fuel heater Activated timer - digital

Symbol in the display for activated timer.

The table shows symbols and display texts that appear.

SymbolDisplaySpecification
Px-1420-Symbol Fuel heaterAuto heater ON

The fuel-driven heater is switched on and operating.

The heater's timer is activated after the remote control key has been removed from the ignition switch and leaving the car - the engine and passenger compartment are heated at the set time.

Px-1420-Symbol Fuel heater

P3007-Symbol LågBatterinivå

Fuel operated heater stopped Battery saving mode

The fuel-driven heater is stopped by the car's electronics in order to facilitate starting the engine.

The starter battery's charge level is too low.

Px-1420-Symbol Fuel heater

Symbol bränslenivå

Fuel operated heater stopped Low fuel level

The fuel-driven heater is stopped.

Setting the heater is not possible due to fuel level being too low - this is in order to facilitate starting the engine as well as approx. 50 km driving.

Px-1420-Symbol Fuel heater serviceFuel operated heater Service required

The fuel-driven heater is fully or partially disengaged.

Visit a workshop if the message remains. Volvo recommends that you contact an authorised Volvo workshop.

Preconditioning interrupted by power supply change

The electrically-driven heater or AC system is stopped.

The transfer of energy is interrupted.

Preconditioning stopped due to malfunction

The electrically-driven heater or AC system is stopped.

Visit a workshop. An authorised workshop is recommended.

Preconditioning stopped Hybrid battery temperature high

The electrically-driven heater or AC system is stopped.

The hybrid battery is too hot, wait until the temperature has returned to normal.

A display text clears automatically after a time or after one press on the indicator stalk OK button.

Related documents