Active main beam

Active main beam is a function which uses a camera sensor at the top edge of the windscreen to detect the headlamp beams from oncoming traffic or the rear lights of vehicles in front, and then switches from main beam to dipped beam.
P5-1617 Stalk with turning ring in AHBC position
Active main beam is activated with the rotating ring on the stalk switch in position P5-1707 Symbol AUTO.

The function can also take streetlights into account. Main beam is reactivated when the camera sensor no longer sees any oncoming vehicles or vehicles ahead.

The function can start while driving in the dark when the car's speed is approx. 20 km/h (approx. 12 mph) or higher.

If active main beam is deactivated while main beam is on, the lighting is immediately reset to dipped beam.

When active main beam is activated, the symbol P5-1507 Symbol AHBC activated illuminates with a white glow in the driver display.

When main beam is activated, the symbol shines blue.

Car with LED1 headlamps*

If the active main beam has the on/off functionality2 then the lighting returns to main beam about a second after the camera sensor no longer detects the headlamp beams from oncoming traffic or the rear lights from vehicles in front.

The lighting returns to full main beam about a second after the camera sensor no longer detects the headlamp beams from oncoming traffic or the rear lights from vehicles in front.

Limitations for active main beam

The camera sensor on which the function is based has limitations.

P5-1519 Symbol Active HeadBeamTempUnavailable

If this symbol is shown in the driver display, together with the message Active High Beam Temporarily unavailable, then switching between main and dipped beam must be performed manually. The rotating ring on the stalk switch can still be in the P5-1707 Symbol AUTO position. The P5-1507 Symbol AHBC activated symbol extinguishes when these message are shown.

P5-1519 Symbol FactoryMode_104

The same applies if this symbol is shown together with the message Windscreen sensor Sensor blocked, see Owner's manual.

Active main beam may be temporarily unavailable e.g. in situations with dense fog or heavy rain. When active main beam becomes available again, or the windscreen sensors are no longer blocked, the message goes out and the P5-1507 Symbol AHBC activated symbol illuminates.

 Warning

Active main beam is an aid for using the optimum beam pattern when conditions are favourable.

The driver always bears responsibility for manually switching between main and dipped beam when traffic situations or weather conditions so require.

  1. 1 LED (Light Emitting Diode)
  2. * Option/accessory.
  3. 2 Depending on the car's equipment level.