In the normal view for the navigation source, press OK/MENU and select .
An excerpt from the current status in the navigation system is shown, e.g. current transmitter of traffic information and operative map data, as well as map version.
Maps - content
Maps are developed with enhanced information and are updated continuously.
Map data does not have 100 percent coverage in all areas/countries.
The system's coverage area is under constant construction and updating may sometimes be necessary.
The car's navigation system varies depending on market. Should you need to modify the map area - contact a Volvo dealer for information on how to proceed.
Updating the maps
Updated map data is downloaded from the InternetSee information on www.volvocars.com/mapupdate to a USB memoryThe USB memory must have at least 20 GB of space available.. The transfer of the downloaded update to the car's navigation system then takes place via the car's USB connection, which is located in the tunnel console's rear storage compartment.
Before update of the car's map data is started:
- First read through the information and instructions from the Internet related to the download and update of map data.
Follow the onscreen instructions in order to update the navigation system - this shows the progress of the update process as well as approximate time remaining.
A number of the Infotainment functions are disabled or reduced during updating.
Start the engine.
Connect the USB memory containing the update to the car's USB connector and follow the onscreen instructions.
The display screen shows Map update finished. All of the navigation system's functions can be used again.
In certain cases, updating map data may also add new functions, which are not described in this manual.
Continue an interrupted update
If the update is not finished when the engine is switched off then the process continues where it left off next time the engine is started, providing the USB memory is still connected. If the USB memory is not connected - start the engine and then connect the USB memory.
The screen shows Map update finished when the update is completed.