Adaptive cruise control

Adaptive cruise control* - temporary deactivation, and standby mode

업데이트됨 7/23/2018

The adaptive cruise control (ACC – Adaptive Cruise Control) helps the driver to maintain an even speed and a safe distance from the vehicle ahead. The cruise control can be temporarily deactivated and set in standby mode.

Temporary deactivation - standby mode with Speed limiter

To temporarily disengage the adaptive cruise control and set it in standby mode:

  • Press the steering wheel button
This symbol and the stored speed's marking then change colour from GREEN to WHITE.

Temporary deactivation - standby mode without Speed limiter

To temporarily disengage the adaptive cruise control and set it in standby mode:

  • Press the steering wheel button

Standby mode due to driver intervention

Cruise control is temporarily disengaged and set in standby mode if:

  • the foot brake is used
  • the gear selector is moved to N position (automatic gearbox)
  • the driver maintains a speed higher than the set speed for longer than 1 minute.

The driver must then regulate the speed.

A temporary increase in speed with the accelerator pedal, e.g. during overtaking, does not affect the cruise control setting - the car returns to the last stored speed when the accelerator pedal is released.

Automatic standby mode

The adaptive cruise control is dependent on other systems, e.g. DSTC (Stability and traction control system). If any of these systems stop working then cruise control is automatically deactivated.

In the event of automatic deactivation a signal will sound and the message Cruise control Cancelled is shown in the combined instrument panel. The driver must then intervene and adapt the speed and distance to the vehicle ahead.

An automatic deactivation can be due to:

  • the driver opens the door
  • the driver takes off the seatbelt
  • engine speed is too low/high
  • speed has fallen below 30 km/h

    Does not apply to a car with Queue Assistant - it can go all the way down to 0 km/h.

  • wheels lose traction
  • brake temperature is high
  • the radar sensor is covered e.g. by wet snow or heavy rain (radar waves blocked).

Resume set speed

Adaptive cruise control in standby mode is reactivated with one press on the steering wheel button - the speed is then set to the last stored speed.

참고

A marked speed increase may occur once the speed has been resumed by selecting .


도움이 되었나요?