Seats, front - electrically operated*
The power seats have overload protection which is tripped if a seat is blocked by an object. If this should happen, set the car's electrical system in key position I or 0 and wait a short time before adjusting the seat again.
Only one movement (forward/back/up/down/inward/outward) can be made at a time.
The seat can be adjusted for a certain time after unlocking the door with the remote control key without the key in the ignition switch. Seat adjustment is normally made in key position I and can always be made when the engine is running.
Seat with memory function*
The memory function stores settings for the seat and the door mirrors.
|Button for storing settings|
The seat must be adjusted again before a new memory can be set.
The setting for lumbar support is not stored.
Using a stored setting
Press one of the memory buttons 1-3 until the seat and the door mirrors stop. If the button is released, the movement of the seat and door mirrors will be interrupted.
Key memory* in remote control key
All remote control keys can be used by different drivers to store the settings for the driver's seat and door mirrors1, see Remote control key - personalisation.
If the seat accidentally begins to move, press one of the setting buttons for the seat or memory buttons in order to stop the seat.
Restarting to reach the seat position stored in the key memory is performed by pressing the unlock button on the remote control key. The driver's door must then be open.
For heated seats, see Heated front seats and Heated rear seat.