The power front seats have overload protection which is tripped if a seat is blocked by an object. If this happens, go to key position I or 0 and wait a short time before adjusting the seat again.
Only one movement (forward/back/up/down) can be made at a time.
The seats can be adjusted for a certain time after unlocking the door with the remote control key without the key in the ignition switch. Seat adjustment is normally made in key position I and can always be made when the engine is running.
Seat with memory function*
The memory function stores settings for the seat and the door mirrors.
|Button for storing settings|
Adjust the seat and the door mirrors.
Hold the button depressed to store settings while depressing one of the memory buttons.
Using a stored setting
Hold one of the memory buttons depressed until the seat and the door mirrors stop. If you release the button then the movement of the seat will stop.
If the seat accidentally begins to move, press one of the setting buttons for the seat or memory buttons in order to stop the seat.
Restarting to reach the seat position stored in the key memory is performed by pressing the unlock button on the remote control key. The driver's door must then be open.
Risk of crushing! Make sure that children do not play with the controls. Check that there are no objects in front of, behind or under the seat during adjustment. Ensure that none of the rear seat passengers is in danger of becoming trapped.