Explore your manual
XC60
2014 Late
Controls
27 Results
Rearview mirror - interior
The interior rearview mirror can be dimmed with a control in the mirror's lower edge. Alternatively, the rearview mirror dims automatically.
Main/dipped beam
With the knob for headlamp control in position and the car's electrical system in key position II or the engine running, the dipped beam is activated automatically in poor light conditions. With the knob for headlamp control in position
dipped beam is always switched on when the engine is running or when key position II is active.
Hazard warning flashers
The hazard warning flashers warn other road users by means of all of the car's direction indicator lamps flashing simultaneously when this function is activated. When the hazard warning flashers are activated both direction indicator symbols flash in the combined instrument panel.
Instruments and controls, right-hand drive car - overview
The overview shows where the car's displays and controls are located.
Interior lighting
The passenger compartment lighting is activated/deactivated with the buttons in the controls above the front seats and the rear seat.
Panorama roof* - operation
The blind/roof is opened to maximum during automatic operation. In ventilation position the front section of the roof is raised at the rear.
Windows and rearview and door mirrors - heating
The defroster is used to quickly remove misting and ice from the windscreen, rear window and door mirrors.
Tunnel detection*
In markets without automatic dipped beam, tunnel detection activates dipped beam when driving into a tunnel. Dipped beam is deactivated approx. 20 seconds after the car has been driven out of the tunnel.
Heating* of the steering wheel
The steering wheel can be heated with electric heating.
Approach lighting
Approach lighting consists of parking lamps, lamps in the door mirrors, number plate lighting, interior roof lighting as well as courtesy lighting.
Door mirrors
The door mirror positions are adjusted with the joystick in the driver's door controls.
Steering wheel
The steering wheel can be adjusted in different positions and has controls for horn and cruise control, as well as menu, audio and phone control.
Home safe light duration
Home safe lighting consists of dipped beam, parking lamps, lamps in the door mirrors, number plate lighting, interior roof lighting as well as courtesy lighting.
Headlamps - adjusting headlamp pattern
If the car is equipped with active Xenon headlamps and has the Active High Beam function then the headlamp pattern must be reset when changing from right to left-hand traffic, and vice versa.
Active Xenon headlamps*
Active Xenon headlamps are designed to provide maximum illumination in bends and junctions and so provide increased safety.
Instruments and controls, left-hand drive car - overview
The overview shows where the car's displays and controls are located.
Rear fog lamp
When visibility is reduced by fog the rear fog lamp can be used so that other road users shall notice vehicles in front at an early stage.
direction indicators
The car's direction indicators are operated with the left-hand stalk switch. The direction indicator lamps flash three times or continuously, depending on how far up or down the stalk switch is moved.
Position/parking lamps
Position/parking lamps are switched on with the headlamp control's knob.
Wipers and washing
Wipers and washers clean the windscreen and rear window. The headlamps are cleaned with high-pressure washing.
Key memory* in remote control key
All remote control keys can be used by different drivers to store the settings for the driver's seat and door mirrors* .
Panorama roof* - general
The panorama roof is divided into two sections. Only the front section can be opened - horizontally or vertically at the rear edge (ventilation position).
Light switches
The headlamp control activates and adjusts the external lighting. It is also used to adjust the display, instrument and passenger compartment lighting.
Brake lights
The brake light automatically comes on during braking.
Power windows
All power windows can be operated using the control panel for the driver's door - the control panels for the other doors operate their respective power window.
Active high beam*
The Active High Beam function detects the headlamp beams of oncoming traffic or the rear lights of vehicles in front, and switches the lighting from main beam to dipped beam. Xenon headlamps only dim the portion of the light beam that points directly to the vehicle. The lighting returns to main beam when the incoming light has stopped.
Daytime running lights
With the knob for headlamp control in position and the car's electrical system in key position II or the engine running, the daytime running lights are activated automatically in good light conditions.