XC90 Twin Engine

2016

Controls for windows, glass and mirrors

Operating power windows

Updated 7/23/2018

All power windows can be operated using the control panel for the driver's door - the control panels for the other doors operate their respective power window.

Warning

Check that no children or other passengers are trapped when the windows are closed from the driver's door.

Warning

Check that no children or other passengers are trapped if/when the windows are closed using the remote control key.

Warning

If there are children in the car - remember to always switch off the power supply to the power windows by setting the car's electrical system in ignition position 0 and then take the remote control key with you when leaving the car.

Operating

Operating the power windows.

Operating the power windows.

Operating without auto
Operating with auto

All power windows can be operated using the control panel for the driver's door - the control panels for the other doors can only each operate their respective power window. Only one control panel can be operated at a time.

In order for the power windows to be used, the ignition position must be at least I. The power windows can be operated for a few minutes after the engine has been switched off and after the ignition has been switched off - although not after a door has been opened.

Closing of the windows is stopped and the window is opened if anything prevents its movement. It is possible to override the pinch protection when closing has been interrupted, e.g. if ice has formed on the window. After two successive closing interruptions the pinch protection will be overridden and the automatic function deactivated for a short while, now it is possible to close by holding the button in its raised position.

Note

One way to reduce the pulsating wind noise when the rear windows are open is to also open the front windows slightly.

Operating without auto

Move one of the controls up/down gently. The power windows move up/down as long as the control is held in position.

Operating with auto

Move one of the controls up/down to the end position and release it. The window runs automatically to its end position.

Operating with the remote control key, door handle or central locking button

To control the power windows from the outside with the remote control key or door handle, or from the inside with the central locking button, see the section "Remote control key", "Locking/unlocking from the outside" or "Locking/unlocking from the inside".

Resetting

If the battery is disconnected then the function for automatic opening must be reset so that it can work correctly.

Gently raise the front section of the button to raise the window to its end position and hold it there for one second.

Release the button briefly.

Raise the front section of the button again for one second.

Warning

A reset must take place for pinch protection to work.


Did this help?