Error message after tyre change

An error message may be shown in the display after you have changed a tyre. If it appears, you need to perform a calibration of the tyre pressure monitoring system.

Calibration of the tyre pressure monitoring system (TM)

Calibration is necessary after a tyre change or a change in tyre pressure.

15w49 - Support site - Tyre pressure instrument cluster
If this symbol illuminates then you need to calibrate the tyre pressure monitoring system.

Calibration is always necessary after a tyre change or a change in tyre pressure. If the lamp illuminates15w49 - Support site - Tyre pressure symbolthen the system needs to be calibrated. Proceed as follows:

With the ignition switched off, inflate all tyres and check the tyre pressure. For more information about tyre pressure, see the tyre pressure label on the driver's side door pillar.
Start the car. Open the menu system My Car and select Tyre pressure.
Select Calibrate tyre pressure and press "OK".
Drive the car for at least 10 minutes no slower than 30 km/h (20 mph). Recalibration takes place while the car is being driven.
15w49 - Support site - Tyre pressure overview - Tyre pressure status
The view for where you start calibration.

 Note

Remember that the system must be calibrated after each tyre change or if the tyre pressure is adjusted.

This article is applicable to

  • Car model/model year

  • V40, V70, XC70 and S80 from and including model year 2015 to and including 2019.

  • S60, V60 and XC60 from and including model year 2015 to and including 2018Does not apply to V60 Plug In-Hybrid, V60 Twin Engine, S60 Polestar (350 hp), V60 Polestar (350 hk)..

  • The range of models, systems and services may vary depending on market.

  • For car models from and including model year 2020, see on-line manual for the model concerned.