Emergency puncture repair kit - inflating the tyres

The car's original tyres can be inflated using the compressor in the emergency puncture repair kit.
The compressor must be switched off. Make sure that the switch is in position 0 and locate the cable and air hose.
Unscrew the wheel's dust cap and screw in the air hose valve connection to the bottom of the thread on the tyre's air valve.


Inhaling car exhaust fumes could result in danger to life. Never leave the engine running in sealed areas or areas that lack sufficient ventilation.


Do not leave children in the car without supervision when the engine is running.
Connect the cable to one of the car's 12 V sockets and start the car.
Start the compressor by flicking the switch to position I.


Risk of overheating. The compressor must not run for more than 10 minutes.

Inflate the tyre to the pressure specified in accordance with the tyre pressure table, Tyres - approved tyre pressures. Release air using the pressure reducing valve if the tyre pressure is too high.

Switch off the compressor Detach the air hose and cable.
Refit the dust cap.