Using the drive modes it is possible to quickly have access to the car's numerous functions and settings for different driving needs. The following systems are adapted to obtain the best possible driving characteristics in each respective drive mode:
- Engine/gearbox/all-wheel drive
- Air suspension and shock absorption
- Driver display
- Start/Stop function
- Climate settings
Select the drive mode that best suits the current driving conditions. Remember that not all drive modes can be selected in all situations.
Selecting drive mode
Press the drive mode control DRIVE MODE.
A pop-up menu is opened in the centre display.
Roll the wheel upward or downward until the desired drive mode is highlighted.
Press the drive mode control or tap directly on the touch screen to confirm the selection.
The selected drive mode is indicated in the driver display.
A message is shown when a drive mode is unselectable, for example:
- Cannot be selected because gear is in manual
- Cannot be selected due to low battery
- Cannot be selected due to low temperature
- Cannot be selected due to limitations
- Cannot be selected because speed is too high.
Selectable drive modes
This is the car's normal mode.
When the car starts, it is in the Comfort mode and the Start/Stop function is activated. These settings mean that the car feels comfortable, the steering is light, the shock absorption is soft and body's movement is smooth.
This drive mode is the certification mode for carbon dioxide emissions.
Adapt the car for more energy-efficient and environmentally-conscious driving with the Eco mode.
The drive mode means e.g. that the Start/Stop function is activated, the ground clearance is lower to reduce wind resistance and the output of certain climate settings is reduced.
The driver display has an Eco gauge that facilitates fuel-efficient driving.
More information on this drive mode is found in the section "Drive mode ECO".
Maximise the car's traction when driving in difficult terrain and on poor roads.
The drive mode provides high ground clearance, steering is light, all-wheel drive and the function for low speed control with hill descent control (Hill Descent Control) are activated. The Start/Stop function is deactivated.
The drive mode can only be activated at low speeds and the speedometer shows the range for speed limitation. If this speed is exceeded, Off Road mode is suspended and another drive mode is activated.
The driver display is supplemented with a compass and altimeter.
The driving mode is not designed to be used on public roads.
If the car is switched off in OFF ROAD mode, and therefore has high ground clearance, the car is lowered next time it is started.
The OFF ROAD drive mode must not be used while driving with a trailer without trailer connector. Otherwise, there is a risk of damage to the air bellows.
Dynamic mode makes the car feel sportier for more active driving.
Steering response is faster, shock absorption is harder and a low ground clearance means that the body follows the roadway in order to reduce roll during cornering. The Start/Stop function is switched off.
Adapting a drive mode according to individual preferences.
Select a drive mode to start from, and then adjust the settings according to the desired driving characteristics.
An individual drive mode is only available if it is first activated in the centre display.
The figure is schematic, the layout may vary depending on car model or updated software.
Press Settings in the top view.
Press Individual Drive Mode.and select
Select a drive mode to start from: Eco, Comfort or Dynamic.
Possible adjustments apply to settings for
- Driver Display
- Steering force
- Powertrain Characteristics
- Brake Characteristics
- Suspension Control.