Adjusting one pedal drive
Braking by using one pedal drive can be adjusted, enabled or disabled in drive settings.
There is a limit to the braking force that can be applied by releasing the accelerator when using one pedal drive. For hard braking you need to use the brake pedal.Warning
- Press the car symbol
in the bottom bar and go to Settings. - Go to Driving→Driving dynamics→One pedal drive.
Select a one pedal drive setting.
Note
Auto setting
When the Auto setting is selected, releasing the accelerator only causes the car to brake if it detects that you are close to a vehicle in front of you.
Automatic creeping
By turning one pedal drive off, you also enable automatic creeping. This means that your car can move slowly without you using the accelerator.
When automatic creeping is active you can temporarily pause it by pressing down hard on the brake pedal until your car is stopped. This activates the hold feature. If you want to initiate creeping again, simply tap the accelerator.
Tip
Quick access
You can also adjust one pedal drive via quick controls in the centre display.