Saving a new reference value for tyre pressure monitoring*
In order for the system for tyre pressure monitoring[1] to work correctly, a reference value for the tyre pressure must be saved. This must take place every time the tyres are changed or the tyre pressure is changed so that the system can warn about low pressure correctly.
Perform the following procedure to store a new tyre pressure as a reference value in the system:
- Switch off the car.
- Inflate the tyres to the correct pressure, see the decal on the door pillar on the driver's side showing the recommended pressure for factory fitted tyres.
- Start the car.
- Press
in the centre display. - Press Car status.
- Press Store pressure.
If storing fails, a message is shown.