Park assist camera

Park assist camera locations and surveillance areas*

Updated 6/14/2021

Park assist camera locations and surveillance areas*

The park assist cameras (PAC Park Assist Camera ) can show rear, front, left or right camera view individually. You can also have a composite 360° view that shows all sides.

360° view*

Px-21w22-iCup-Park Assist Camera 360 view with angle buttons

Example of how all camera symbols are shown in the 360° view.

The 360° view function activates all parking cameras, whereupon the four sides of the car are shown simultaneously in the centre display, which helps the driver to observe what is around the car when manoeuvring at low speed. From the 360° view, each camera view can be activated separately. Tap on the screen to show the camera symbols and select the desired view. The camera symbols will disappear after a short time without the screen being touched.

The cameras can be activated automatically or manually.

Backwards

P6-21w24-XC40/XC40H/XC40BEV-ParkingCam-Rear

The backward-facing camera shows a wide area behind the car. For certain models, part of the bumper can be seen as well as the towbar in some cases.

Objects shown in the centre display may appear slightly tilted – this is normal.

Forwards

P6-21w24-XC40/XC40H/XC40BEV-ParkingCam-Front

The front camera can be helpful on an exit road with limited visibility to the sides, e.g. when driving out of a garage. It is active at speeds up to 25 km/h (16 mph) - following which, the front camera is switched off.

If the car does not reach 50 km/h (30 mph) and the speed falls below 22 km/h (14 mph) within 1 minute after the forward-facing camera has been extinguished, the camera is reactivated.

The sides

P6-21w24-XC40/XC40H/XC40BEV-ParkingCam-Side

The side cameras can show what is along each side of the car.


Did this help?