Dimension designation for tyre

Designations for tyre dimension, load index and speed rating.

The car has an approval for the complete vehicle with certain combinations of wheel rims and tyres.

Designation of dimensions

All tyres have a dimension designation, such as: 235/60 R18 103 V.

235

Tyre width (mm)

60

Ratio between tyre wall height and tyre width (%)
RRadial ply

18

Rim diameter in inches

103

Codes for the maximum permitted tyre load, tyre load index (LI)

V

Speed rating for maximum permitted speed, speed rating (SS). (In this case 240 km/h (149 mph).)

Load index

Each tyre has a certain capacity to carry a load, a load index (LI). The car's weight determines the load capacity required of the tyres.

Speed rating

Each tyre can withstand a certain maximum speed. Tyre speed rating, SS (Speed Symbol), must at least correspond with the car's top speed. The table below shows the maximum permitted speed for each speed rating (SS). The only exception to these regulations is winter tyres1, where a lower speed rating may be used. If such a tyre is chosen, the car must not be driven faster than the speed rating of the tyre (for example, class Q can be driven at a maximum of 160 km/h (100 mph).) The top speed at which the car can be driven depends on road conditions, not the speed rating of the tyres.

 Note

The maximum permitted speed is specified in the table.
Q160 km/h (100 mph) (used only on winter tyres)
T190 km/h (118 mph)
H210 km/h (130 mph)
V240 km/h (149 mph)
W270 km/h (168 mph)
Y300 km/h (186 mph)

 Warning

The lowest permitted tyre load index (LI) and speed rating (SS) for the tyres for each respective engine variant are shown in the specifications, which can be found in the printed owner's manual. If a tyre with too low a load index or speed rating is used, it may overheat and be damaged.
  1. 1 Both those with metal studs and those without.