Level control* and shock absorption
Level control regulates the car's suspension and shock absorption characteristics automatically to ensure the best comfort and functionality while driving. It is also possible to adjust the level manually in order to facilitate loading or entry and exit.
Air suspension and shock absorption
The system is adapted according to the selected drive mode and according to the speed of the car. Using the air suspension, the car's ground clearance is adjusted to a lower level at higher speeds, which reduces wind resistance and increases stability. Shock absorption is normally set for the best possible comfort and is regulated continuously depending on the road surface, the car's acceleration, braking and cornering.
The driver display indicates when level control is in progress.
The level cannot be regulated when the tailgate or any side door is open.
During parking
During parking, make sure you allow adequate space above and below the car since the car's ground clearance may vary e.g. depending on the outside temperature, how the car is loaded, the use of loading mode or the drive mode that is selected after starting.
The level may also be adjusted some time after the car has been parked. This is to compensate for any changes in height that may occur due to temperature changes in the air springs when the car cools down.
During transport
During transport of the car on a ferry, train or truck, the car must be lashed around the tyres and not around other parts of the chassis. Changes in the air suspension may occur during transport, which could affect the lashing negatively.
Symbols and messages in driver display
Symbol | Message | Specification |
---|---|---|
Suspension Deactivated by user | Level control has been switched off manually by the user. | |
Suspension Temporarily reduced performence | Level control performance has been temporarily reduced due to extensive system use. If this message appears frequently (e.g. several times in one week) contact a workshop1. | |
Suspension Service required | A fault has occurred. Visit a workshop1 as soon as possible. | |
Suspension failure Stop safely | A critical fault has occurred. Stop safely, have the car transported (raised with all wheels on the flat-bed) to a workshop1. | |
Suspension Slow down Car too high | A fault has occurred. If the message appears whilst driving, contact a workshop1. | |
Suspension Auto adjusting car level | Level control to target height in progress. |