Wipers and washers
Windscreen wipers off
Move the stalk switch to position 0 to switch off the windscreen wipers.
Raise the stalk switch and release to make one sweep.
Set the number of sweeps per time unit with the thumbwheel when intermittent wiping is selected.
The wipers sweep at normal speed.
The wipers sweep at high speed.
Service position wiper blade
The rain sensor automatically starts the windscreen wipers based on how much water it detects on the windscreen. The sensitivity of the rain sensor can be adjusted using the thumbwheel.
When the rain sensor is activated a lamp in the button is illuminated and the rain sensor symbol is shown in the combined instrument panel.
Activating and setting the sensitivity
When activating the rain sensor, the car must be running or the remote control key in position I or II while the windscreen wiper stalk switch must be in position 0 or in the position for a single sweep.
Activate the rain sensor by pressing the rain sensor button . The windscreen wipers make one sweep.
Press the stalk switch up for the wipers to make an extra sweep.
Turn the thumbwheel upward for higher sensitivity and downward for lower sensitivity. (An extra sweep is made when the thumbwheel is turned upward.)
Deactivate the rain sensor by pressing the rain sensor button or move the stalk switch down to another wiper program.
The rain sensor is automatically deactivated when the remote control key is removed from the ignition switch or five minutes after the engine has been switched off.
Washing the headlamps and windows
Washing the windscreen
Move the stalk switch toward the steering wheel to start the windscreen and headlamp washers.
The windscreen wipers will make several more sweeps and the headlamps are washed once the stalk switch has been released.
Heated washer nozzles*
The washer nozzles are heated automatically in cold weather to prevent the washer fluid freezing solid.
High-pressure headlamp washing*
High-pressure headlamp washing consumes a large quantity of washer fluid. To save fluid, the headlamps are washed automatically at every fifth windscreen wash cycle.
If only approx. 1 litre of washer fluid remains in the reservoir and the message that you should fill the washer fluid is shown in the combined instrument panel, then the supply of washer fluid to the headlamps is switched off. This is in order to prioritise cleaning the windscreen and the visibility through it.