The safety net is fitted into four mounting points.
A safety net prevents loads or pets from being thrown forward in the passenger compartment in the event of sudden braking. For safety reasons, the safety net must always be correctly fastened and secured.
The net is made of a strong nylon fabric and can be secured two different locations in the car:
- Rear fitting - behind the rear seat backrest.
- Front fitting - Behind the front seat backrests.
It is necessary to ensure that the upper securing points of the safety net are fitted correctly and that the snap hooks are hooked in properly.
Damaged nets must not be used.
Hook the net's other retaining hook into the roof mounting on the opposite side - the telescopic spring-loaded retaining hooks facilitate alignment.
Take care to press forward the net's retaining hooks for each respective roof mounting's front end position.
Rear fitting: With the net fitted in the rear roof mountings, hook the safety net's snap hooks into the front floor eyes in the cargo area.
Front fitting: With the net fitted in the front roof mountings, hook the safety net's snap hooks into the eyes on the rear of the seat slide rails - it is easier if the backrests are straightened and the seats are moved forward slightly.
Pay attention to make sure that you do not press the seat/backrest hard against the net when the seat/backrest is moved back again - only adjust until the seat/backrest makes contact with the net.
Removal and storage
The safety net can be easily removed and folded up.
The folded safety net can be stored under the cargo compartment floor.