Operating the high beam
You can control the high beam using the left-hand steering wheel stalk.
There are several different high beam options you can choose from to suit the driving conditions.
You can move the left-hand stalk forward or backward to switch between the different high beam options. The stalk always springs back to the neutral position.
The options available are:
- High beam on
- High beam off
- High beam flash
Note
Primary lighting modes
To use the high beam, you must first select the automatic or passing beam primary lighting mode.
Activating the high beam
- Push the stalk once to activate the high beam.
Deactivating the high beam
- Pull the stalk all the way towards you to turn the high beams off.
Flashing the high beam
- A short pull of the stalk activates the high beam flash.
Make sure that the vehicle cameras are well-maintained and kept clean. If the cameras’ views are obscured by dirt, they will not be able to obtain enough information to properly direct the car’s lighting responses.Important