Jump starting using another battery

If the vehicle doesn't start, it could be because the 12 V battery is discharged. It can then be charged using another vehicle's 12 V battery or an external charger.

Under normal conditions, the 12 V battery is charged when the vehicle is charged, and through electrical current transfer directly from the high-voltage battery when the vehicle is not plugged in for charging.

If the 12 V battery becomes discharged for any reason, it can be jump-started. There are several reasons why a battery may become discharged, such as the vehicle not being used for a long period of time, a temporary malfunction or a blown fuse in the vehicle's charging circuit. A discharged 12 V battery needs to be charged in order to start the vehicle and power its electrical systems. After startup, it is possible to start charging of the vehicle using a charging cable, which is necessary when the high-voltage battery is also discharged. If the vehicle is out of range for charging, it must be towed.

To jump-start the vehicle, jumper cables must be connected to the vehicle's charging points for the 12 V battery.

To access the charging points, a number of panels under the hood must be removed.

 Important

The charging points of the vehicle are only intended for jump-starting the vehicle in question. The charging points are not intended for jump-starting another vehicle. Using the charging points to start another vehicle could cause a fuse to blow, which would cause the charging points to stop working.

If the message 12 V battery fuse failure Service required is displayed in the instrument panel, a fuse has blown and needs to be replaced. Volvo recommends contacting an authorized Volvo workshop.

P6-2222-Jump lead clamp placement
A number of the panels around the storage compartment need to be removed to access the charging points under the hood.

To avoid short circuits or other damage, the following steps are recommended when jump starting the battery using another battery:

Put the vehicle's electrical system in Passive usage mode.
Make sure that the assisting battery has a voltage of 12 V.
If the battery is in another vehicle, turn off that vehicle's engine and make sure that the vehicles are not touching each other.
Attach one end of the red jumper cable to the assisting battery's positive terminal (1).

 Important

Handle jumper cables carefully. A short circuit can occur if the ends come in contact with any other surface than the charging points.
Open the cover over the positive charging point (2) by pressing in its side to release the catch while lifting the cover upward. There are two connecting points under the cover. Use the one closest to the center of the vehicle.
Clamp the other end of the red jumper cable to your vehicle's positive charging point (2).
Clamp one end of the black jumper cable to the assisting battery's negative terminal (3).
Clamp the other end of the black jumper cable to your vehicle's negative charging point (4).
Make sure the jumper cable's clamps are securely attached. Poor contact can cause sparks or the clamps to loosen during the start attempt.
Start the motor of the assisting vehicle.
Start the vehicle with the discharged battery by depressing the brake pedal and selecting gear position D or R.

 Important

Do not touch the connections between the cable and the vehicle during the start attempt. Risk of sparking.

 Note

Full startup is indicated by the indicator lights on the instrument panel going out and its preselected theme illuminating.
If the high-voltage battery is also discharged, begin charging of the vehicle using the charging cable.

Remove the jumper cables in the reverse order ‒ first the black cables and then the red cables.

Make sure that the clamps of the black jumper cables do not come into contact with the vehicle's positive charging point, the assisting vehicle's battery's positive terminal, or the red jumper cable's clamps.

 Note

A discharged 12 V battery must be charged for a while in order to power the vehicle's electrical systems. At an ambient temperature of about +15 °C (about 60 °F), the battery must be charged by the vehicle for at least 30 minutes. At lower ambient temperatures, the charging time can increase to 3-4 hours. If possible, the battery should be charged using an external battery charger.

 Warning

PROPOSITION 65 WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the state of California to cause cancer and reproductive harm. Wash hands after handling.

 Warning

  • The 12 V battery can generate oxyhydrogen gas, which is very explosive. A spark caused by an incorrectly connected jumper cable could be enough to make the battery explode.
  • The 12 V battery contains sulfuric acid, which could cause serious burn injuries.
  • If contact with eyes, skin or clothing occurs, flush the affected area immediately with water. Obtain medical help immediately if eyes are affected.
  • Never smoke near the battery.