Bulbs – headlight housing
The entire headlight housing must be lifted out when replacing all front bulbs.
Removing the headlight housing
 | Pull out the headlight housing's locking pins. |
 | Remove the headlight housing by alternatively pulling the front and rear edges until it can be lifted out. |
Important
When disconnecting the connector, pull on the connector itself and not on the wiring.
 | Unplug the wiring connector by holding down the clip with your thumb. |
 | Pull the connector out with the other hand. |
| 5. | Lift out the headlight housing and place it on a soft surface to avoid scratching the lens. |
| 6. | Replace the defective bulb(s). |
Reinserting the headlight housing
Plug in the connector until it clicks into place.
Reinstall the headlight housing and locking pins. The short locking pin should be closest to the grille. Check that they are correctly inserted.
The headlight housing must be properly in place and the wiring connector correctly reconnected before the lighting is switched on or the remote key is inserted into the ignition slot.
Check that the lights function properly.