Changing a wheel – removing wheel

Wheel changes should always be carried out correctly.
P3-1020-S60 Tools in luggage compartment

The jack*, towing eyelet and tools* are stowed under the floor of the trunk.

Changing a wheel

Apply the parking brake and put the gear selector in P.
Take out the jack*, lug wrench*, the tool for removing the plastic covers on the wheel nuts, the towing eyelet and the wheel cover removal tool (certain models only) stowed under the floor of the trunk.
P3-1446-tool for removing plastic hat on wheel screws
Tool for removing the plastic covers on the wheel nuts

Remove the wheel cover (where applicable) using the removal tool or remove the wheel cover by hand.

Block the wheels that are on the ground with wooden blocks or large stones.
P3-1320-Ny hjulskruvsnyckel
Lug wrench and towing eyelet
Screw the towing eyelet into the lug wrench as shown in the illustration.

 Important

The towing eyelet must be screwed into the lug wrench as far as possible.
P3-1320-Ny hjulskruvsnyckel losstagning

With the vehicle still on the ground, remove the plastic covers on the wheel nuts with the tool provided and use the lug wrench/towing eyelet to loosen the wheel nuts ½ – 1 turn by exerting downward (counterclockwise) pressure.

P3-1020-S60-LIFTING POINTS hoist
Jack attachment points
There are two jack attachment points on each side of the vehicle. Position the jack under the attachment point to be used on a level, firm, non-slippery surface and crank it up until it is correctly aligned and seated in the attachment point. Before raising the vehicle, check that the jack is still correctly positioned in the attachment.
Raise the vehicle until the wheel to be changed is lifted off the ground.
Unscrew the wheel nuts completely and remove the wheel.

 Warning

  • The jack must correctly engage the jack attachment.
  • Be sure the jack is on a firm, level, non-slippery surface.
  • Never allow any part of your body to be extended under a vehicle supported by a jack.
  • Use the jack intended for the vehicle when changing a tire. For any other job, use stands to support the vehicle.
  • Apply the parking brake and put the gear selector in the Park (P) position.
  • Block the wheels standing on the ground, use rigid wooden blocks or large stones.
  • The jack should be kept well-greased and clean, and should not be damaged.
  • No objects should be placed between the base of jack and the ground, or between the jack and the attachment bar on the vehicle.

 Note

The jack provided with your vehicle is intended to be used only in temporary situations such as changing wheels in the event of a flat tire. Only the jack that came with your particular model should be used to lift the vehicle. If the vehicle needs to be lifted more frequently or for a prolonged period, using a garage jack or hoist is recommended. Always follow this device’s instructions for use.
  1. * Option/accessory.