Adjusting suspension settings Polestar Engineered*
The shock absorber settings can be adjusted for driving in other conditions or on particular road surfaces.
Location of adjustment knobs
There are four adjustment knobs, two for the front shock absorbers and two for the rear. There are adjustment knobs above each wheel. The adjustment knobs for the front wheels are located under the engine compartment hood. The adjustment knobs for the rear wheels are located above each wheel in the wheel housing.


Each adjustment knob has 22 adjustment positions. The closer to position 0 the knob is set, the stiffer the suspension.Note
Adjusting front suspension settings
Make sure the adjustment knob is set to 0 before starting the adjustment. This makes it easier to determine what adjustment position is set.


Turn the knob clockwise until it stops to get to adjustment position 0.

Turn the knob counterclockwise to the desired adjustment position. You should feel and hear a click each time the adjustment position is changed.
Then follow the same procedure for the second tire.
Adjusting rear suspension settings
The rear adjustment knobs are located above the tire inside the wheel housing. To access the rear adjustment knobs, the vehicle must be raised using a jack; see separate section.



Remove the protective rubber cap over the adjustment knob.

Turn the knob clockwise until it stops to get to adjustment position 0.

Turn the adjustment knob counterclockwise to the desired adjustment position. You should feel and hear a click each time the adjustment position is changed.
When the desired position has been reached, replace the protective rubber cap. Then follow the same procedure for the second tire.
For optimal performance, Volvo recommends setting the adjustment knobs to the same position for each axle.Note
Recommended positions
| Position | Front | Rear |
| Performance mode | adjustment position 2 | adjustment position 4 |
| Engineered, factory setting | adjustment position 6 | adjustment position 9 |
| Comfort mode | adjustment position 12 | adjustment position 15 |