Adaptive Cruise Control

Activating and starting Adaptive Cruise Control*

Updated 1/31/2020

Activating and starting Adaptive Cruise Control*

Adaptive Cruise Control (ACCAdaptive Cruise Control) must first be activated and then started before it can regulate speed and distance.

Putting Adaptive Cruise Control in standby mode

P5-1507-ACC På

Adaptive Cruise Control is in standby mode each time the engine is started. To put ACC in standby mode from active mode:

Press (2) or (3) on the steering wheel keypad and scroll to the (4) function.

The symbol will appear and Adaptive Cruise Control will go into standby mode.

Starting/activating Adaptive Cruise Control

To start ACC:

  • The driver's seat belt must be buckled and the driver's door must be closed.
  • There must be a vehicle ahead (target vehicle) within a reasonable distance or your vehicle's current speed must be at least 15 km/h (9 mph).
P5-1507-ACC På

With the (4) function displayed, press (1) on the steering wheel keypad.

Adaptive Cruise Control will start and the current speed will be stored, which will be shown by numbers in the center of the speedometer.

P5-1519-xc90H-Symbol DA

ACC will only regulate the time interval to the vehicle ahead when the distance symbol shows two vehicles.

P5-1507-ACC Hastighet skillnad

A speed interval will be marked at the same time.

The higher speed is the set speed for your vehicle and the lower speed is the speed of the vehicle ahead (target vehicle).


Did this help?