Detachable towbar - attachment/removal
Attaching
Remove the protective cover by first turning the screws a quarter turn 
. Then slide the cover diagonally downward and forward in order to release and finally pull it backwards to remove it 
.
Ensure that the mechanism is in the unlocked position by turning the key clockwise.
The indicator window must show red.
Insert the towbar until you hear a click.
The indicator window must show green.
Turn the key anticlockwise to locked position. Remove the key from the lock.
Check that the towbar is secure by pulling it up, down and back.
Warning
Important
Safety cable.
Warning
Removing the towbar
Insert the key and turn it clockwise to the unlocked position.
Push in the locking wheel and turn it anticlockwise until you hear a click.
Turn the locking wheel down fully, until it comes to a stop. Hold it in this position while pulling the towbar rearward and upward.
Warning
Secure the towbar safely if it is stored in the car, see Detachable towbar - storage.
Refit the protective cover by wedging the cover's hooks into the bumper's rear edge. Push the cover upward until the bolts are in the correct position . Finally, turn the bolts a quarter turn so that the cover is attached. It is important that the handle of the bolts is set transversely during assembly.