Safety grille*

The safety grille prevents loads or pets in the cargo area from being thrown forward in the passenger compartment in the event of sudden braking. For reasons of safety the safety grille must always be mounted and secured correctly.

The safety grille's parts consist of the grille and two loose attaching braces. The attaching braces each come with a screw cap and there are two plastic sleeves for the safety grille.

 Warning

Under no circumstances may anybody remain in the cargo area while the car is moving. This is to avoid injury in the event of heavy braking or an accident.

 Warning

The safety grille must only be used in the rear position described here. The roof mountings behind the front seats are not intended for the safety grille.

 Warning

For safety reasons, the third seat row1 must be lowered when the safety grille is fitted in the car.

 Important

It is not possible to have the protective grille fitted at the same time as the cargo cover.

Installation

Lower the rear seat and then lift the safety grille in through one of the rear side doors or via the tailgate - the arched/convex side of the grille should face the cargo area while the hooks on each side point up. The attaching braces and plastic sleeves are not used in this stage.
P5-1507 Protection grid step 1

Guide one of the safety grille's hooks into the larger opening in the roof mounting (1).

Grasp the grille near the hook and pull/slide it towards the smaller opening (2).

The hook is now secured in the roof mounting's end position.
Repeat the steps in point 2 above to secure the other hook in the mounting on the other side.

 Warning

Make sure the hooks of the safety grille are securely fitted in the roof mountings so there is no risk of the grille coming loose.
P5-1507 Protection grid step 2

Hook the attaching brace's hook through the load securing eyelet at the cargo floor from underneath, and guide the threaded part through the cargo grille's lower attachment hole from underneath (1).

Slide a plastic sleeve on the threaded part of the attaching brace - the sleeve flange should face up - and guide it down through the hole. Then screw on the screw cap until its lower edge is approx. 5 mm from the grille (2).

Repeat the steps in point 4 on the other side.
Centre the safety grille and then tighten the two attaching braces alternately until the grille is properly secured.

Removal

To remove the safety grille - proceed in reverse order from the installation instructions above. Note that the attaching braces can be removed before the plastic sleeves are removed from the holes in the grille.

  1. * Option/accessory.
  2. 1 Applies to 7-seat cars.