V40 Cross Country

2015 Early

Controls

Main/dipped beam

Updated 7/23/2018
Stalk switch and knob for headlamp control.

Stalk switch and knob for headlamp control.

Position for main beam flash
Position for main beam

Dipped beam

With the knob in position, dipped beam is activated automatically at dusk or when daylight becomes too weak. Dipped beam is also activated automatically when the rear fog lamp is activated.

With the knob in position, dipped beam is always switched on when the engine is running or when key position II is active.

Main beam flash

Move the stalk switch gently towards the steering wheel to the position for main beam flash. Main beam comes on until the stalk switch is released.

Main beam

Main beam can be activated when the knob is in position When dipped beam is activated. or . Activate/deactivate main beam by moving the stalk switch towards the steering wheel to the end position and then releasing. Alternatively, the main beam can be deactivated by a light press of the stalk switch toward the steering wheel.

When main beam has been activated the symbol illuminates in the combined instrument panel.


Did this help?