Emergency puncture repair

Emergency puncture repair kit* - location

Updated 7/23/2018

The emergency puncture repair kit, Temporary Mobility Kit (TMK), is used to seal a puncture and check and adjust the air pressure.

Location of the emergency puncture repair kit

Version 1.

Version 1.

Version 2.

Version 2.

Set up the warning triangle if a tyre is being sealed in a trafficked location. The warning triangle and emergency puncture repair kit are located under the floor in the cargo area.

Lift the rear edge of the luggage compartment floor (or on models with a jointed luggage compartment floor, take hold of the luggage compartment floor handle, lift and move the rear part of the floor forwards).

Lift out the storage compartment (optional extra) - models with a jointed luggage compartment floor only.

Lift out the lower floor (models with a jointed luggage compartment floor only).

Unhook the elastic part of the belt over the TMK compressor unit on the left side.

Lift the TMK compressor unit straight up.

To access the bottle of sealant, it must be pushed to the left until it can be lifted out of the foam block.

Note

To access the towing eye/wheel wrench in the foam block:

  • Version 1: Lift the emergency puncture repair kit compressor unit (point 5) to access the wheel wrench. Lift out the bottle of sealant (point 6) to access the towing eye.
  • Version 2: Lift the emergency puncture repair kit compressor unit (point 5) to access the towing eye. The wheel wrench is located underneath the jack.

After use, hook the belt back onto the left side.

Version 1: The belt must be pulled behind the foam block (not above).

Version 2: The belt must be in the fork on the rear part of the foam block.


Did this help?