Securing loads

On both sides of the car's cargo area there are several mounting points designed for securing loads.
P3007-Lastsäkringspunkter
Mounting point locations in the cargo area.

The mounting points are located in the floor and in the top edge of both sides of the cargo area.

 Warning

Hard, sharp and/or heavy objects which protrude may cause injury under violent braking.

Always secure large and heavy objects with a seatbelt or cargo retaining straps.

Floor rails

Golvskena m last mellan 4 krokar
Load secured in both upper and lower mounting points.

In the floor of the cargo area there are two rails with movable cargo retaining hooks for securing items in the cargo area using cargo retaining straps.

Dirt and objects collecting down in the rails could hinder the repositioning, locking, raising and removal of the cargo retaining hooks. Make it a habit to clean the tracks with a vacuum cleaner and a lightly-moistened soft cloth.

 Important

Do not use straps with exchange as these may pull the mounting points apart.

Load retaining straps

Y2- Band runt lastsäkringskrok
Strap retention.

One loop of the load retaining strap around one of the load retaining hooks secures the strap and prevents it from sliding around the hook.

 Note

A suitable width for a cargo retaining strap is approx. 25 mm.

Moving a cargo retaining hook

Golvskena m flyttad krok
Ikon röd pil 1

Fold the load retaining hook down in the direction to which its opening points.

Ikon röd pil 2

Press the hook down lightly and at the same time push it to the required position.

Ikon röd pil 3

Fold the hook up – it is self-locking.

 Note

There must be at least 50 cm between the load securing hooks in the rail.

Removing a load retaining hook

v70-746-Golvskena golvkrok-urtag

The load retaining hooks can be easily removed from the rail, e.g. for cleaning the bottom of the rail.

Ikon röd pil 1

Fold the load retaining hook down in the direction to which its opening points.

Ikon röd pil 2

Press the hook down lightly and at the same time slide it to the cut-out opening.

Ikon röd pil 3

Lift the hook straight up.

Securing the hook takes place in reverse order.

 Note

Any hook removed must be pushed down slightly to be able to push it back into the rail.

Load retaining hook correctly fitted/incorrectly fitted

Golvskena m Rätt/Fel krok
Fit the load retaining hooks correctly!

It is important that the load retaining hooks are fitted correctly. The hooks' openings must point away from each other.

 Warning

Fit the load securing hooks correctly. Otherwise the load securing strap may fold down the load securing hook, causing it to come loose and the strap to slip off.

Related documents