Trip computer - analogue combined instrument panel
Information from the trip computer can be shown in the combined instrument panel and operated with the controls on the left-hand stalk switch and with the combined instrument panel's menu.
Checking and settings can be made immediately after the combined instrument panel is automatically illuminated in connection with unlocking. If none of the controls are actuated within approx. 30 seconds after the driver's door has been opened then the instrument extinguishes, after which either key position II or engine starting is required in order to operate the trip computer.
Note
If a warning message appears when the trip computer is used then the message must first be acknowledged before the trip computer can be reactivated.
- Acknowledge the message by briefly pressing the indicator stalk OK button.
Controls
OK – opens the combined instrument panel's menu, confirms messages or menu selections.
Thumbwheel - browses between menu options or trip computer options.
RESET - resets the current trip meter or goes back out of the menu structure.
Trip computer alternative
- To ensure that no control is in the middle of a sequence - reset them first with two presses on RESET.
- Turn the thumbwheel to browse between the options and stop at the required heading.
The trip computer display in the combined instrument panel can be shifted to another option at any time during the journey. One of the options means that no trip computer is shown.
| Trip computer heading in combined instrument panel | Information |
|---|---|
| Trip meter T1 and total dist. |
|
| Trip meter T2 and total dist. |
|
| Distance to empty | For more information - see the section"Range - distance to empty tank". |
| Fuel consumption | Current consumption. |
| Average speed |
|
| No trip computer information. | This option shows a blank display and it also indicates the beginning/end of the loop. |
Resetting the trip computer
- Turn the thumbwheel and stop at the trip computer heading to be reset: T1 and total dist., T2 and total dist. or Average speed.
One long press on RESET resets the value for the selected heading.
Each heading must be zeroed individually.
Functions in the combined instrument panel's menu
Open the combined instrument panel's menu to activate selectable headings in the trip computer.
- Press OK.
- Scroll between menu options using the thumbwheel and select TC options.
- Select the preferred alternatives. The symbols for the options already selected are white with a "tick" - others are grey and have no "tick".
- Finish by pressing twice on RESET after completed checking/adjustment.