Tire sealing system* – general information

Certain models are equipped with a tire sealing system* that enables you to temporarily seal a hole in the tread surface and re-inflate a flat tire, or to adjust a tire’s inflation pressure.

P3-1220-XC60-new TSS foam block

Introduction

The tire sealing system consists of an air compressor, a container for the sealing compound, wiring to connect the system to the vehicle’s electrical system via one of the 12-volt sockets, and a hose used to connect the system to the tire’s inflation valve.

 Note

The tire sealing system's compressor has been tested and approved by Volvo.

The 12-volt sockets are located in the front tunnel console, on the rear side of the center console in the rear seat and in the cargo area*.

Accessing the tire sealing system

The tire sealing system is stowed under the floor of the cargo area. To access it:

  1. Lift the floor hatch in the cargo area.
  2. Lift out the tire sealing system.

 Note

  • The tire sealing system is only intended to seal holes on the tire’s tread area, not the sidewall.
  • Tires with large holes or tears cannot be repaired with the tire sealing system.
  • After use, stow the tire sealing system properly to help prevent rattling.

 Warning

  • After using the tire sealing system, the vehicle should not be driven farther than approximately 120 miles (200 km).
  • Have the tire inspected by a trained and qualified Volvo service technician as soon as possible to determine if it can be permanently repaired or must be replaced.
  • The vehicle should not be driven faster than 50 mph (80 km/h) while using a tire that has been temporarily repaired with the tire sealing system.
  • After using the tire sealing system, drive carefully and avoid abrupt steering maneuvers and sudden stops.

Tire sealing system–temporarily repairing a flat tire

P3/P4-1246-ALL- new version of TMK 2

Temporarily repairing a flat tire is done in two stages:

  • Stage 1: The hole is sealed by pumping sealing compound into the tire. The car is then driven a short distance to distribute the sealing compound in the tire.

 Note

Do not remove any foreign objects (nails, etc.) from the tire before using the sealing system.
  • Stage 2: The tire’s inflation pressure is checked and adjusted if necessary.

 Warning

  • Never leave the tire sealing system unattended when it is operating.
  • Keep the tire sealing system away from children.
  • Be sure the vehicle is parked safely off the road and away from moving traffic.
  • Apply the parking brake.
  1. * Option/accessory.

Related documents