Bulbs – headlight housing

The entire headlight housing must be lifted out when replacing all front bulbs.

Removing the headlight housing

P3-1320-XC60 Headlight removal 2
Ikon röd pil 1Pull out the headlight housing's locking pins.
Ikon röd pil 2Pull the headlight housing straight out.
P3-1320-XC60 Headlight removal 3

 Important

When disconnecting the connector, pull on the connector itself and not on the wiring.
Ikon röd pil 3 Unplug the wiring connector by holding down the clip with your thumb.
Ikon röd pil 4Pull the connector out with the other hand.
5.Lift out the headlight housing and place it on a soft surface to avoid scratching the lens.
6.Replace the defective bulb(s).

Reinserting the headlight housing

P3-1320-XC60 Headlight fastening

When reinserting the housing, be sure that the long locking pin is securely in place in both of its retaining clamps.

Plug in the connector until it clicks into place.

Reinsert the headlight housing and locking pins. Check that they are correctly inserted.

The headlight housing must be properly in place and the wiring connector correctly reconnected before the lighting is switched on or the remote key is inserted into the ignition slot.

Check that the lights function properly.