Operating the panoramic roof*

The panoramic roof and sun curtain are operated using a control in the ceiling panel, and both are equipped with pinch protection.

 Warning

Children, other passengers or objects can be trapped by the moving parts.

  • Always operate the windows with caution.
  • Do not allow children to play with the operating controls.
  • Never leave a child alone in the vehicle.
  • Remember to always cut the current to the power windows by setting the vehicle's electrical system to ignition mode 0 and then taking the remote key with you when leaving the vehicle.
  • Never stick objects or body parts out through the windows, even if the vehicle electrical system is completely turned off.

 Important

  • Do not open the panoramic roof when load carriers are installed.
  • Never place heavy objects on the panoramic roof.

 Important

  • Remove ice and snow before opening the panoramic roof. Be careful not to scratch any surfaces or damage the trim.
  • Do not operate the panoramic roof if it is frozen in place.

To operate the panoramic roof and sun curtain, the ignition must be in mode I or II.

It can also be operated using keyless opening* with the door handle.

 Warning

Make sure that no child or other passenger comes into contact with the windows as they are closing with keyless closing*.

 Important

Check that the panoramic roof is properly closed when closing.

The movement of the roof will stop if the control is released during manual operation or when the glass has reached the comfort1 or fully open/closed position. The movement of both the panoramic roof and the sun curtain is also stopped if the control in the ceiling is operated again in the direction opposite that of the current direction of movement.

The panoramic roof and sun curtain are also equipped with pinch protection. If there is any problem with the pinch protection, a rest procedure can be tested.

 Note

For manual opening, the sun curtain must be completely open before the panoramic roof can be opened. For the reverse procedure, the panoramic roof must be completely closed before the sun curtain can be completely closed.

 Note

It may not be possible to operate the windows in low temperatures.

Opening and closing ventilation position

P5-1746-Panorama roof-ventilation position
Ventilation position, rear edge raised.
  1. P5-Icon red arrow 1Open by pushing the control upward once.
  2. P5-Icon red arrow 2Close by pushing the control downward once.

When ventilation mode is selected, the rear edge of the front section of the roof is raised. If the sun curtain is fully closed when ventilation position is selected, it will automatically open approx. 50 mm (approx. 2 inches).

If the panoramic roof is closed from the ventilation position, the sun curtain will also automatically close.

Fully opening and closing the panoramic roof with the control in the ceiling

P5-1746-Panorama roof-operating from roof
  1. P5-Icon red arrow 1Operation, manual mode
  2. P5-Icon red arrow 2Operation, automatic mode

Manual operation

To open the sun curtain, pull the control backward to the manual open mode.

To open the panoramic roof to the comfort position, pull the control backward a second time to the manual opening position.

To open the panoramic roof fully, pull the control backward a third time to the manual opening position.

Close by repeating the above procedure in reverse - push the control forward/down to the manual closing position.

Auto operation

To open the sun curtain to the fully open position, pull the control backward to the auto open mode and release.

To open the panoramic roof to the comfort position, pull the control backward a second time to the automatic opening position and release.

To open the panoramic roof fully, pull the control backward a third time to the automatic opening position and release.

Close by repeating the above procedure in reverse - push the control forward/down to the auto close position.

Automatic operation - rapid opening or closing

The panoramic roof and sun curtain can be opened or closed simultaneously:

Open - press the control backward twice to the automatic operation position and release.
Close - press the control forward/down twice to the automatic operation position and release.
  1. * Option/accessory.
  2. 1 The comfort position is a position which helps keep wind and resonance sounds to a comfortably low level.